Belt Drive Parts

"ULTIMATE" CLUTCH PRESSURE PLATE KIT FOR BDL BELT DRIVES

Weight: 3.12 Designed to fine tune the exact pressure needed to match your powerplants horsepower output. Allows your choice of using up to two diaphragm springs, or four to twelve coil type springs. Will not fit BDL® top fuel belt drive or BDL®...

BELT DRIVE BELT GUIDE PLATES FOR BIG TWIN

Weight: 0.17Stamped steel and anodized. It contours to the front pulleys and helps guide the belt as well as protecting the alternator from belt rub. Used on all of our 1 1/2" 8mm and 11mm front pulleys except early tapered shaft.Guide fits inside of...

BELT DRIVE IDLER BEARING KIT FOR BELT DRIVE SYSTEM

Weight: 1.65This high quality Primary Belt Drive Idler Bearing Kit is used to adjust the belt tension. Small adjustable serrated plate attaches to the large solid mounted stock plate within the cast inner primary. The rollers bearings are permanently...

CLUTCH PARTS FOR BIG TWIN 10 SPRING CLUTCH

Weight: 0.05V-FACTORClutch Pushrod Oil Seal fits Big Twin 10 spring clutch 1941/LaterReplacement Single Lip Seal for 77422 & 77423Package of 5(Imported)

ENGINE PULLEY NUT LOCK KIT FOR BDL OPEN BELT DRIVES

Weight: 0.38Designed to keep the crankshaft nut from backing off on BDL open belt drivesLockplate is manufactured from laser cut 3/16" stainless steelIncludes 5/16-18 x 2" grade 8 allen bolts and 5/16" I.D. 6061 aluminum spacers for use with offset ...

ENGINE/PULLEY NUTS AND WASHERS FOR BELT DRIVE BIG TWIN

Weight: 0.16Some folks like to show and some just want to go! Either way, we have you covered. For best results, always install the correct washer, especially on front pulleys that have a removable steel center.Belt Drives Ltd.Cadmium Plated hex style...

ENGINE/PULLEY NUTS AND WASHERS FOR BELT DRIVE BIG TWIN

Weight: 0.14Some folks like to show and some just want to go! Either way, we have you covered. For best results, always install the correct washer, especially on front pulleys that have a removable steel center.Belt Drives Ltd.Cadmium Plated WasherFits...

ENGINE/PULLEY NUTS AND WASHERS FOR BELT DRIVE BIG TWIN

Weight: 0.18Some folks like to show and some just want to go! Either way, we have you covered. For best results, always install the correct washer, especially on front pulleys that have a removable steel center.JimsZinc Plated (Grade 8) hex head...

ENGINE/PULLEY NUTS AND WASHERS FOR BELT DRIVE BIG TWIN

Weight: 0.22Some folks like to show and some just want to go! Either way, we have you covered. For best results, always install the correct washer, especially on front pulleys that have a removable steel center.ColonyChrome Plated (Grade 5) acorn...