Namz

Namz #NCBC-N01 - Controller CAN Bus - FX/XL

Does not work with keyless ignition bikesFeaturesAllows fot the use of custom handlebar switch controlsPlug the unit into the factory harness under the fuel tank and wire up any pre-CAN Bus handlebar...

Namz #NSC-01 - Momentary Switch Converter

Momentary Switch ConverterFeaturesIntended for custom applications where momentary switches are used for a high/low headlight switch and run/kill switchModule converts the momentary switch into a...

Namz #NITS-R02 - Rear Red LED Turn Signals - Indian

Rear Red LED Turn Signals - IndianFeaturesKit includes LED inserts, lenses and grommetsFor use with Badlands Illuminator module Part # 2050-0260; sold separatelyPlug-n-playSpecsProduct...

Namz #NTI-IND-01 - Trailer Isolator Harness - 5-Wire - Indian

For use with 5-wire trailers.FeaturesFeatures left, right, brake, turn and ground wire outputsMade in the USASpecsConnector TypeTrailerFeatures5-WireUnitsKitTypeTrailerProduct NameWiring HarnessFor...

Namz #NTI-4-5 - Trailer Isolator Module - 5-Wire - FL/FX

Trailer Isolator Module - 5-Wire - FL/FXFeaturesProtects factory turn signal lighting module from being overloaded when adding a trailerPlug in between the OEM rear fender wiring harness and receives...

Namz #NTIC-IND-01 - Trailer Isolator Harness - 4-Wire - Indian

For use with 4-wire trailers.FeaturesFeatures left, right, brake, turn and ground wire outputsMade in the USASpecsFor MakeIndianProduct NameWiring HarnessConnector...

Namz #NHAP-01 - Headlight Adapter Pigtail - 14-Up FLHR

Headlight Adapter Pigtail - 14-Up FLHRFeaturesUse when installing Daymaker LED headlampsMade in the USASpecsTypeHeadlightColor/FinishBlackFor MakeHarley Davidson®Product NameAdapterRiding...

Namz #NO2X-1201 - O2 Sensor Harness Extension and Bung Adapter - 18 mm to 12 mm

Allows the use '09 dresser exhaust pipes on '10 dresser models. (Includes bung reducers)FeaturesNow you can use '09 Dresser exhaust pipes on '10-'16 Dresser modelsReduces the 18 mm O2 bungs on '09...

Namz #NO2X-1202 - O2 Sensor Harness Extension - 18 mm to 12 mm

Allows the use of '09 dresser exhaust pipes on '10 dresser models & '12 FXST & FXD Models. (Includes bung reducers, installed terminals without connectors)FeaturesAllows the use of exhaust...

Namz #NNSE-P01 - Neutral Switch Eliminator Plug - '84-'17 Big Twin

Neutral Switch Eliminator Plug - '84-'17 Big TwinFeaturesThe 1/4" blind allen-head design uses an o-ring to seal once tightened from the inside of the trans top coverMade from highly polished,...

Namz Oxygen Enrichment Devices (#NR-FL-XIED-09)

Oxygen Enrichment Device Install in a few minutes; simply plug in between the oxygen sensors and the OEM wiring harness Recommended for models with high-flow air intakes and exhausts Reduce your...

Namz Oxygen Enrichment Devices (#NR-XIED)

Oxygen Enrichment Device Install in a few minutes; simply plug in between the oxygen sensors and the OEM wiring harness Recommended for models with high-flow air intakes and exhausts Reduce your...

Namz Oxygen Enrichment Devices (#NR-O2-IED)

Oxygen Enrichment Device Install in a few minutes; simply plug in between the oxygen sensors and the OEM wiring harness Recommended for models with high-flow air intakes and exhausts Reduce your...

Namz #NHC-CH206 - Oil Line Hose Clamps - Chrome - 3/8" - 6-Pack

Oil Line Hose Clamps - Chrome - 3/8" - 6-PackFeaturesCustom-colored hose clamps designed for use with braided copper and stainless steel hoses, and fit over most manufacturer's braided rubber...

Namz #NHC-CH106 - Fuel Line Hose Clamp - Chrome - 1/4" - 5/16" - 6-Pack

Fuel Line Hose Clamp - Chrome - 1/4" - 5/16" - 6-PackFeaturesCustom-colored hose clamps designed for use with braided copper and stainless steel hoses, and fit over most manufacturer's...