Thundermax_Components_BLP

Thundermax #309-324 - Pigtail ECM Harness

Requires ThunderMax ECM with serial number 114000 or higher (produced beginning August 2008). Will not work on previous model ThunderMax part # 232661 TBW unit.Installed into the bike's wiring harness at the 36-pin ECM connector (connection requires...

Thundermax #309-355 - Replacement Oxygen Sensor

Replacement Oxygen SensorFeaturesEasy installation: replace the factory ECM, install new O² sensors and harness, load the correct map for your bike, and rideReplacement oxygen sensor for Thundermax ECM auto tune systemMade in the USABecause of possible...

Thundermax #309-424 - Pigtail USB Harness

Requires ThunderMax ECM with mini USB communication port (beginning November 2012). Will not work on previous model ThunderMax ECM or part # 1020-0836 (Touring TBW units).Installed into the bike's wiring harness at the 36-pin ECM connector (connection...

Thundermax #EA4093 - Push Button Converter - Harley Davidson

Push Button Converter - Harley DavidsonFeaturesConvenient way to wire up push-button hand control switchesTakes momentary signal from a push-button hand control switch and converts it to a standard "latching" signalDesign is fully...

Thundermax #EA4094 - Center Module - Brake Light - Harley Davidson

Center Module - Brake Light - Harley DavidsonFeaturesAllows installation of a center brake light on choppers and custom bikes when used with Thunder Heart’s Micro Harness Controller part # 2120-0023Compatible with LED and incandescent bulbsSolid-state...

Thundermax #EA4250D-C - Electronic Harness Controller

Electronic Harness ControllerFeaturesAllows a dual-filament bulb to be used in three ways: tail, brake and turn signal (excluding the need for a center brake light); includes ribbon cable for integrating generic indicator lightsPerforms all fuse, relay...

Thundermax #EA4260 - Micro Harness Controller

For choppers and custom bikes w/o separate brake light (except '04-'20 Big Dog w/proprietary hand controls)FeaturesPerforms all fuse, relay (includes starter relay) and signal-canceling functions in one simple packageProvides multiple flasher...

Thundermax #EA4360 - Micro Harness Controller

For choppers and custom bikes w/o separate brake light (except '04-'20 Big Dog w/proprietary hand controls)FeaturesPerforms all fuse, relay (includes starter relay) and signal-canceling functions in one simple packageProvides multiple flasher...

Thundermax #EA5012 - Stand-Alone Ignition System - Twin Cam

Stand-Alone Ignition System - Twin CamFeaturesDesigned for use in custom applications where a Twin Cam motor and crank sensor are usedComplete ignition system includes module, coil, wires, Smart Link software, communication cable and instructions (no...

Thundermax #EA7000 - Oil Cooler Fan - M8 Touring/Trike

If running with stock ECM, visit a local dealer to have the bike flashed.FeaturesUses engine temp and vehicle speed to reduce heat and keep engines running coolTakes only 15 minutes to install; does not require oil cooler removalPlug-n-play installation...